zedboard硬件连接过程

2.      Set the Boot Mode jumpers to Cascaded JTAG Mode

3.      Connect a micro-USB cable between the Windows Host machine and theUSBUART: a. ZedBoard connector J14 (UART)

4.      <ZedBoard Only> Slide the ZedBoard powerswitch to ON. You should see the Green Power Good LED (LD13light.s 上电以后绿LED亮起

5.      Use Device Manager to determine the COM port for the USB-UART. InWindows 7, click Start à Control Panel, and thenclick Device Manager. Click Yes to confirm.

6.       Win7：打开设备管理器：在控制面板中选择硬件和声音进入页面：点击设备管理器将打开设备管理器页面：

7.    In SDK, select Xilinx Tools à Program FPGA or click the icon.蓝色led亮起说明配置正确

版权声明：本文为博主原创文章，未经博主允许不得转载。

zedboard硬件连接过程

标签：